HobbyPlus Machine Aluminum Front Portal Hub Set V2 use for CR18P EVO PRO & CR18P EVO/JUICE UP

Description : - Use for CR18P EVO/EVO PRO/JUICE UP  - 1 set x Optional Aluminum SOA Conversion

Description : - Use for CR18P EVO PRO/CR-18P 2024 - Machined Overdrive Portal Gears 20%

HobbyPlus Brass Front Portal Hub V2 use for CR18P EVO/CR18P EVO PRO/JUICE UP

HobbyPlus Rear Portal Hub  Brass Weight  V2 use for CR18P EVO PRO/EVO/JUICE UP

Description : - Use for Arktos 6x6 - 1 x Aluminum Skid Plate

Description : - Use for Arktos 6x6 - 1 x Complete Ball Bearing Set (Rubber Seal)

Fits:- CR18P V3 Rushmore, Trail Hunter- CR18P Pro Juice Up- For use with bushings or bearings

Specifications:- Charge Plug Type: JST XH-4P Connector- Power Plug Type: XT30 Connector - Voltage: 7.4V- Capacity: 1100 mah

Special Notes:- The included pinion gear is helical design and is required to install on the motor shaft.- The V3 Rushmore and THunter will have a lower ratio with these gears. If you want to maintain the same gear ratio, you will need to...

Description : - Use for Arktos 6x6 - 1 x Machine Aluminum Rear Axle

Specifications:- Hex Size: 7mm- Hex Pin Size: 1.5mm- Weight: TBDWhat's Included:- +10mm Axles x 4- 1.5mm Solid Pins x 4- Brass Hexes x 4 Features:- Brass Hexes for Increasing Weight while Decreasing COG (Center of Gravity)- +10mm Axles     - Increases Track Width for...

Description : - Use for Arktos 6x6 - 1 x SHD Steel Machine Pinion & Ring gear ( 11T/28T ) Set 

HobbyPlus Machined HD Helical Cut Pinion and Ring Gear 11T/28T

What it Fits:- Front or Rear Axle for the Terranaut 8x8/DK4 What's Included:- Machined Axle Housing x 1- Machined Diff Cover x 1- Hardware x 8pcs